Rockwell Automation 2364P Overhead Bus for Bulletin 2300 MCCs - Manual (Page 7)

Publication 2364P-5.10 - December 1999
7
7. Mount the bus assemblies to the MCCs as shown in Figure 6 (use the
taptite hardware that was previously removed in step 1). Tighten the
screws.
8. Torque the feeder and bus splices to 45 lb-ft (61 N-m).
9. Install the joiner enclosures for the bus splices and feeder splice (as
shown in Figure 6). Tighten the screws.
10. Install the end cap (see Figure 6). Tighten the screws.
Figure 6
Installation Example–Steps 7 - 10
7 8
45 lb-ft
45 lb-ft
9
10
Rear of MCC
M6 self-tapping screws
(typ.)
(61 N-m)
(61 N-m)
#10 Taptite Screws
Step Step
Step
Step
M6 self-tapping
screws (typ.)