Rockwell Automation 2711-NP1 Mounting Clips Installation Instructions - Manual (Page 3)

3 Publication 2711-2.12
Installation Instructions
Mounting Clips
Catalog Number 2711-NP1
English
The package of mounting clips (Catalog No. 2711–NP1) contains 10
clips. Use these clips to mount the following:
•
PanelView 1400 Operator Terminal (requires 10 clips)
•
6180 Industrial Computer (requires 10 clips)
•
14 inch Industrial Monitors (requires 6 clips)
Mounting Clip Installation 1. Refer to the installation instructions provided with the operator
terminal, monitor, or industrial computer.
2. Clips are positioned in the chassis mounting slots. Tighten the
mounting clip using the screwdriver slot on the clip. Refer to the
device’s installation instructions for specific torque values and
tightening sequences.
Aquí se muestra el PanelView 1400, otros dispositivos son
similares
Screwdriver slot for tightening clip