Rockwell Automation 2705-E3 RediPanel Jumper Wire - Manual

Publication 2705-5.0
RediPANEL Jumper Wire
(Catalog Number 2705-E3)
The RediPANEL Jumper Wire Catalog Number 2705-E3 is designed
for use on custom RediPANEL modules with 800E operators during
installation of 3-position selector switches.
Instructions for wiring 3-position illuminated switches appear in
Appendix B of Bulletin 2705 RediPANEL Push Button Modules User
Manual (Publication 2705-800). Those instructions describe an
installation in which the required additional contact cartridge is taken
from the right adjacent pushbutton.
In some situations you may find it necessary to take the required
additional contact cartridge from the left adjacent pushbutton. This
document contains instructions for using the jumper wire to
complete such an installation. The jumper wire is needed to provide
power for the relocated N.O. contact block because the existing
power supply wire will not reach.
!
ATTENTION: Do not apply power to the RediPANEL
module until all electrical connections, including
communications lines, have been connected.
Installation Instructions
Applicability