Rockwell Automation 4000 Series 4000 LED Universal Control Bases, Open and Closed Types User Manual

Page 4

Advertising

PA-8829 Ver 01

November 2012

Printed in USA

Power, Control and Information Solutions Headquarters

Americas: Rockwell Automation, 1201 South Second Street, Milwaukee, WI 53204-2496 USA, Tel: (1) 414.382.2000, Fax: (1) 414.382.4444
Europe/Middle East/Africa: Rockwell Automation NV, Pegasus Park, De Kleetlaan 12a, 1831 Diegem, Belgium, Tel: (32) 2 663 0600, Fax: (32) 2 663 0640
Asia Pacific: Rockwell Automation, Level 14, Core F, Cyberport 3, 100 Cyberport Road, Hong Kong, Tel: (852) 2887 4788, Fax: (852) 2508 1846

www.rockwel lautomation.com

Wiring

The basic wiring diagram for the Series 4000 control base is shown on
page 4 of this bulletin. However, the control circuit wiring connections
will depend on the plug-in control function and light source/receiver
combination (or scanner) used. These application wiring connections are
described in detail in the appropriate plug-in control function module
bulletins: See page 2 of this bulletin for proper reference.

All external wiring should conform to the provisions of the National
Electric Code and applicable local codes. Rigid or flexible conduit may
be used for interconnection of units, but rigid conduit for maximum
electrical shielding is recommended for any extensions of the
photoelectric receiver cable.

All photoswitch control circuits are filtered to reduce the effect of
transients, but since all electronic circuits are to some degree transient
susceptible, care should be taken to avoid unnecessary coupling of
transients into the circuit. The most efficient method of wiring the Series
4000 control is to bring the line voltage and output leads in from the top
and the low voltage leads from the bottom.

The photodetector wiring should never be run in the same conduit as
the power wiring.

IMPORTANT

Warranty

We guarantee for one year from date of shipment to replace or, at our
option, to repair any products or parts thereof (except lamps, electronic
tubes and photocells) which are found defective in material or
workmanship or which otherwise fail to con form to the contract
description or to any warranty, expressed or implied.

We make no warranties which extend beyond the description of our
product on the face of our sales orders.

The Purchaser's remedies with respect to any product or part sold by us
shall be limited exclusively to the right to replacement or repair as above
provided. In no event shall we be liable for consequential or special
damages of any nature which may arise in connection with such product
or part.

LINE VOLTAGE

Series 4000 control base wiring

LED SOURCE CONNECTIONS

RECEIVER CONNECTIONS

For complete wiring information,

refer to proper control module

bulletin.

Advertising