Wiring options for the 2085-iq32t module – Rockwell Automation 2085-IQ16_IQ32T 24V DC 16 and 32 Sink/Source Input Modules User Manual

Page 10

Advertising

10 Micro800 16-point and 32-point 12/24V Sink/Source Input Modules

Publication 2085-IN001A-EN-P - September 2012

Wiring Options for the 2085-IQ32T Module

Included with your 2085-IQ32T module is a keyed 40-pin female connector and crimp type
pins. These components allow you to wire I/O devices to the module using a 40-conductor cable
or individual wires.

When assembled, align the female connector over the module’s male header using the keying slot
as a guide. Firmly lock them together with the upper and lower retaining arms.

ATTENTION: To comply with the CE Low Voltage Directive (LVD), all connected I/O must be
powered from a source compliant with the following:

Safety Extra Low Voltage (SELV) or Protected Extra Low Voltage (PELV).

WARNING: Do not unlatch the connector retaining arms or remove the connector while power
is on. This could cause an explosion in hazardous location installations. Be sure that power is
removed before proceeding.

ATTENTION: To comply with UL restrictions, this equipment must be powered from a source
compliant with the following:

Class 2 or Limited Voltage/Current.

I-00

I-01

I-02

I-03

I-04

I-05

I-06

I-07

I-08

I-09

I-10

I-11

I-12

I-13

I-14

I-15

COM0

COM1

I-16

I-17

I-18

I-19

I-20

I-21

I-22

I-23

I-24

I-25

I-26

I-27

I-28

I-29

I-30

I-31

COM2

COM3

45300

2085-IQ32T

Advertising