Rockwell Automation 6186M-xxxx Industrial Performance Monitors Installation Instructions - Manual (Page 8)

8 Industrial Performance Monitors
Rockwell Automation Publication 6186M-IN002C-EN-P - December 2011
Application Information
The circuit parameters of associated field-wired apparatus for use in hazardous locations shall be
coordinated with the host product such that their combination remains nonincendive. The
Industrial Performance monitors and USB peripheral devices shall be treated in this manner.
The circuit parameters of the Industrial Performance monitors’ USB ports are given in the
Industrial Performance Monitors USB Port Circuit Parameters table. The monitor provides two
separately powered USB ports.
The USB peripheral devices and their associated cabling shall have circuit parameters with the
limits given in the Required Circuit Parameters for USB Peripheral Devices table for them to
remain nonincendive when used with the Industrial Performance Monitors’ USB ports.
For the comparison of C
a (USB)
and C
i (peripheral)
, use the capacitance of each individual
connected USB peripheral device and its associated cable C
cable
.
For the comparison of L
a (USB)
with L
i (peripheral)
, use the inductance of each individual
peripheral device and its associated cable for L
i
.
If cable capacitance and inductance are not known, the following values may be used:
C
cable
= 60 pF/ft (197 pF/m)
L
cable
= 0.20 μH/ft (0.66 μH/m)
European Union Directive Compliance
This product meets the European Union Directive requirements when installed within the
European Union or EEA regions and has the CE mark. A copy of the Declaration of Conformity
is available at the following website:
http://www.rockwellautomation.com/products/certification/ under Product Certification.
Backlight Assembly Disposal
ATTENTION: This product is intended to operate in an industrial or control-room
environment, which utilizes some form of power isolation from the public low-voltage
mains. Some computer configurations may not comply with the EN 61000-3-2 Harmonic
Emissions standard as specified by the EMC Directive of the European Union. Obtain
permission from the local power authority before connecting any computer
configuration that draws more than 75 W of AC power directly from the public mains.
ATTENTION: The backlight assembly in this unit contains mercury. At the end of its life, this
equipment should be collected separately from any unsorted municipal waste.