Rockwell Automation 2706-P22R InView Panel Mount Message Display Installation Instructions - Manual (Page 3)

Publication 2706-IN014B-MU-P
Installation Instructions
English Section
InView Panel Mount Message Display
(Catalog Number 2706-P22R)
Overview
This document describes how to install an InView Panel Mount display and
contains these topics:
•
Wiring and safety guidelines
•
Mounting and dimensions
•
Power connections
•
DIP switch settings
•
Specifications
For additional information, refer to:
•
InView User Manual, publication 2706-UM016.
•
The InView User Manual can be found in the Manuals-On-Line section of
www.ab.com or theautomationbookstore.com.
Wiring and Safety Guidelines
Install the InView display conforming to NFPA 70E, Electrical Safety Requirements
for Employee Workplaces. In addition to the NFPA general guidelines, refer to the
following:
Careful cable routing helps minimize electrical noise. Route incoming power to the
module by a separate path from the communication cables.
Do not run communications wiring and power wiring in the same
conduit!
Where communication and wire paths must cross, make their intersection
perpendicular.