Rockwell Automation 2755 Hand-Held Cordless Bar Code Scanners - Manual (Page 151)

A–34 Application Examples
Publication 2755-6.6
DTAM Plus DeviceNet
This application example describes how to configure and operate the
scanners when using an RS-232 cable connected to a DTAM
Operator Interface (Catalog Nos. 2707-L8P1, 2707-L8P2,
2707-L40P1, 2707–L40P2, 2707–L40P4, 2707-V40P1,
2707-V40P2, or 2707-V40P2N) on a DeviceNet network.
!
ATTENTION: Do not install the RS-232 cable with
power applied to either the base/charger unit or DTAM
Operator Interface. Failure to follow this caution may
result in damage to the scanner, base/charger unit, or
DTAM Operator Interface.
Refer to the following publications for additional information.
•
DTAM Plus Operator Interface Module User Manual
(Publication No. 2707-800)
•
DTAM Plus Devicenet Operator Interface Document Update
(Publication No. 2707-800.5)
•
DTAM Programming Software Programming Manual
(Publication No. 2707-802)
•
Getting Started with DTAM Plus User Manual
(Publication No. 2707-802)