Rockwell Automation 2711-NR8K MicroView to PanelView 300 Micro Adapter Plate - Manual (Page 2)

Publication 2711-IN051A-EN-P - September 2005
2 MicroView (Bulletin 2707) to PanelView 300 Micro (Bulletin 2711) Adapter Plate
Tools Required The following tools are required for installation:
• socket driver with 7 mm (M4) deep socket
• small slotted screwdriver
• torque wrench capable of 1.13 Nm (10 in-lb)
Disconnect the Terminal 1. Disconnect power at the source and remove the power cord
from the MicroView terminal.
2. Disconnect all communication cables from the terminal
Remove the Existing
Terminal 1. Remove the mounting nuts that secure the terminal in the panel.
2. Slide the existing terminal out from panel.
SHOCK HAZARD Labels may be located on or inside the equipment (e.g.,
drive or motor) to alert people that dangerous voltage may
be present.
BURN HAZARD
Labels may be located on or inside the equipment (e.g.,
drive or motor) to alert people that surfaces may be
dangerous temperatures.
ATTENTION
Make sure the power cord of the MicroView
terminal is disconnected and that all cables
have been disconnected from the terminal.