Rockwell Automation 2755 Decoded Hand-Held Scanner - Manual (Page 58)

Communication Setup (Cable Configuration) 4-2
Publication 2755-6.2
Setting RS-232 Synapse Cable Options
The following define the communication options available when the
scanner is connected to one of the following RS-232 Synapse cables:
•
Catalog No. 2755-HFC-SR2-01
•
Catalog No. 2755-HFC-SR3-01
Default Settings
Scanning the SET RS-232 SYNAPSE CABLE DEFAULTS bar code sets
the following parameters:
Item Default Setting
Refer to
Description
on Page:
Programming
Guide ➀
Page Reference
Host Standard RS-232 4-3 3-3
Baud Rate 9600 4-3 3-4
Parity None 4-4 3-5
Check Parity Enabled 4-4 3-5
Stop Bits 1 4-4 3-6
Data Bits 8 4-4 3-6
Hardware
Handshaking
None 4-5 3-7
RTS State Low 4-5 3-7
Software
Handshaking
None 4-6 3-8
Beep on BEL Enabled 4-7 3-9
Unknown Characters
Send Bar Codes With
Unknown Characters
4-7 3-9
Response Timeout 2 seconds 4-7 3-10
Parameter Set Set #1 4-8 3-12
➀ Bar Code Programming Guide for Decoded Scanners (Publication 2755-6.5).