Rockwell Automation 61C615 RTD Termination Panel - Manual (Page 12)

3Ć2
Step 4. Connect the 50Ćpin flat cables to the termination panel and
to their corresponding connector on the analog input
module (61C613). Attach the cables by aligning the
triangle marks on the cable end and the board socket.
Input channels 0Ć7 use the middle connector on the input
module. Input channels 8Ć15 use the bottom connector. If
the rack contains more than one analog input module,
make certain that the connectors are the proper ones for
this module.
Step 5. Turn on power to the system.
Step 6. Verify the installation. Refer to the instruction manual for
the 16 Channel Analog Input Module (JĆ3613Ć1).
3.3 Panel Replacement
Use the following procedure to replace a termination panel:
Step 1.
Turn off power to the rack and all connections.
Step 2. Use a screwdriver to loosen the screws holding the field
wires to the termination panel. Make certain that the wires
are tagged so that they can be reĆconnected correctly.
Step 3. Remove the 50Ćpin flat cables from the back of the
termination panel.
Step 4. Remove the termination panel.
Step 5. Follow steps 2 through 6 in the installation procedure,
section 3.2.