Rockwell Automation 2090-CCPP8S8 Kinetix 6000M Hybrid Power Coupler Install - Manual (Page 4)

4 Kinetix 6000M Hybrid Coupler Cable
Publication 2090-IN038B-EN-P - March 2012
ATTENTION: The examples in this publication show the available connections, some of which may
not be appropriate for your specific installation. Refer to your system level installation instructions
or user manual for recommended wire trim lengths, and wiring examples appropriate to your
application.
Failure to observe these safety procedures could result in personal injury or damage to the motor
and equipment.
ATTENTION: Do not tightly gather or coil the excess length of a hybrid cable. Heat is generated
within a cable whenever power is applied. Always position a hybrid cable to freely dissipate heat.
A hybrid cable should not be coiled, except for temporary use when building or testing a machine.
If you temporarily coil a hybrid cable, you must also derate the cable to meet local code or follow
an authoritative directive, such as Engineering Section 310.15(C) of the NEC Handbook.
Failure to observe these safety procedures could result in personal injury or equipment damage.