Rockwell Automation 6155F-NPWEDC Compact Non-display Computer - Manual (Page 34)

34 Rockwell Automation Publication 6155R-UM002E-EN-P - February 2014
Chapter 4 Component Replacement
4. Insert the CF card into the slot and make sure it is properly seated.
5. Reinstall the bottom plate as detailed in Reinstall the Bottom Plate on
page 32 .
6. Follow the steps for Post-configuration on page 31 .
Drive Precautions Follow these precautions when working with a drive.
• Do not touch internal components.
• Always handle the drive by its frame.
• Never remove or install a drive with the power on.
• Store the drive in an antistatic bag when it is not installed.
ATTENTION: When properly seated, more than 80% of the CF card easily
inserts into the slot before you encounter resistance. If you encounter
resistance before then, remove the card, rotate it 180°, and reinsert.
Do not force the card into the slot. Forcing the card into the slot can
damage the connector pins.
IMPORTANT Back up or clone your computer before replacing a drive.
SHOCK HAZARD: Electrostatic discharge (ESD) can damage the computer and
components. Read and follow
Electrostatic Discharge Precautions on page 30
before removing a drive.
Failure to follow proper safety precautions can result in severe electrical shock to
an individual or ESD damage to the computer and its components.
ATTENTION: Mechanical shock can damage a drive. Do not drop or bump the
drive.