Rockwell Automation DC2-71, 78, 91, and 98 Drive Fuse Kit Options For all DC2 Controllers except - Manual (Page 2)

2
F2DC2000 Fuse Kit
DANGER
DO NOT INSTALL MODIFICATION KITS WITH POWER APPLIED TO THE UNIT. DISCONNECT AND
LOCK OUT INCOMING POWER BEFORE ATTEMPTING SUCH INSTALLATION. FAILURE TO
OBSERVE THIS PRECAUTION COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
(Refer to Figure 1 for fuse kit connections.)
To Controller
Terminal 51 To Controller Terminal L1 if Controller
has no operator devices.
To Start/Stop Switch Terminal 4 (Wire
151) if Controller has operator deĆ
vices.
Figure 1. Fuse Kit Connections.
DC2Ć50 Series:
ă1. Disconnect and lockout all incoming power to
the DC2 Controller.
ă2. Place the fuse holder over the preĆdrilled holes
on the chassis and then install using the two
taptite screws provided in the plastic bag with
this kit.
ă3. Remove the jumper wire between L1 and 51.
ă4. Using a flathead screwdriver, connect the wire
labeled 51" to terminal 51 of the Controller.
ă5. Cut the lug from the end of the fuse kit wire laĆ
beled L1" and then strip 0.5 inch of insulation
in preparation for connection.
ă6. Using a flathead screwdriver, connect the wire
labeled L1" to terminal L1 of the Controller.
ă7. Install the fuse into the holder.
DC2Ć60 and DC2Ć80 Series:
ă1. Disconnect and lockout all incoming power to
the DC2 Controller.
ă2. Use aphillips head screwdriver to remove the
four (4) screws from the faceplate of the ConĆ
troller.
ă3. Place the faceplate on the side of the Controller
to gain access to the preĆdrilled holes located
above the grounding bar.
ă4. Install the fuse holder assembly on the chassis
above the grounding bar (below the Regulator
board) using the two taptite screws provided
in the plastic bag with this kit.
ă5. Remove the jumper wire between L1 and 51.
ă6. Using a flathead screwdriver, connect the wire
labeled 151" to terminal 51 of the Controller.
ă7. Using a flathead screwdriver, connect the
jumper wire (labeled `L1') to terminal L1 of the
Controller.
ă8. Install the fuse into the holder.
ă9. Place the faceplate on the controller and then
install the four screws removed in step 2 of this
procedure.
DC2Ć70 and DC2Ć90 Series (DC2Ć71, DC2Ć78,
DC2Ć91 and DC2Ć98 are not included):
ă1. Disconnect and lockout all incoming power to
the DC2 Controller.
ă2. Use aphillips head screwdriver to remove the
four (4) screws from the faceplate of the ConĆ
troller.