Rockwell Automation 20D Lifting Mounting PowerFlex 700S and 700H Drives (Frame 10 - 14) - Manual (Page 7)

Lifting & Mounting PowerFlex® 700S and 700H Drives (Frames 10 - 14) 7
Step 2: Removing the Skid
and Shipping Feet
!
ATTENTION: To guard against personal injury and equipment
damage, do not work under the drive unless the drive is securely
mounted on appropriate blocks.
Task Description
Using a 15 mm wrench, remove the hardware that secures the drive to the skid.
Lift the drive off of the skid.
Place the drive on proper blocks on a hard level surface. The blocks should be
approximately 10 cm (4 inches) high.
Using a 17 mm wrench, remove the hardware that secures the shipping feet to the drive
and remove the shipping feet.
A A
A A B
A C
A C D
A
B
C A
A
C
D
D
D