Rockwell Automation T3835 ICS Regent Software Validation Package for Winterpret - Manual (Page 7)

Software Validation Package for Winterpret (T3835)
P D - 6 0 4 5 M a r c h , 0 6
7
Table 1.
Failure Modes and Effects Analysis of Application Program
Creation and Download Path.
Failure Mode (due
to random or
systematic faults)
Method of Detection for
Application Programs
Method of Detection
for GPL Templates
Editing / entry error Mis-compare of readable
Source to original
specification Mis-compare of Echo
File to original template
specification
Source File corrupted CRC error upon attempt at
source file retrieval, &/or
mis-compare of readable
Source to original
specification
CRC error upon attempt
at source file retrieval,
&/or mis-compare of
Echo File to original
template specification
Compiler error Mis-compare of Check
File and Echo File Mis-compare of Echo
File to original template
specification
Download corruption Mis-compare of Check
File and Echo File Mis-compare of Echo
File to original template
specification
Application alteration
due to Regent
memory error Caught by triplicated
voting / processing of data Caught by triplicated
voting / processing of
data
Software Installation
The Software Validation Package is installed on the PC
running the W
INTERPRET application software. The
W INTERPRET base package provides the necessary installation
software to install this add-in validation package. The
validation package should be installed at the same time or
after you have installed the W
INTERPRET base package.
Installation Procedure
The files on the validation package diskette are in compressed
form. You cannot simply copy the files to your hard drive —
they must be decompressed before they will run. You must
have the W
INTERPRET base package distribution disk in order
to run the setup procedure to install the validation package.
To install the Software Validation Package, use the following
sequence:
Important!