Rockwell Automation AK-U0-RJ45-SC1 RJ45 Splitter Cable Instructions (DSI MDI) - Manual

Installation Instructions RJ45 Splitter Cable (Catalog No. AK-UO-RJ45-SC1)
for use with DSI/ MDI Drive Products
Important: For connectivity guidelines relating to all configurations, see next page.
Connecting One Temporary Peripheral Connecting Two Permanent Peripherals
Connecting One Temporary Peripheral
and One Permanent Peripheral
Connecting an RS-485 Network
M
S
DSI / MDI Drive
Serial Converter
Parameter 1 [Adapter Cfg] set to "Auto"
(default) or "Master" and connected to
Master port (M) on RJ45 Splitter Cable
Sel Esc
LANG DISP Esc Esc Sel Sel
8 9 ALT 7
4 5 6 Jog
1 2 3
. 0 +/-
DSI
REMOVE
DSI / MDI
Hand Held
or
Parameter 9 [Device Type] set to "Auto"
(default) or "Master" and connected to
Master port (M) on RJ45 Splitter Cable
M
S
NEMA 4
Panel Mount Unit
or
NEMA 1 Bezel
with DSI / MDI
Hand Held
DSI /MDI Drive
or
Parameter 9 [Device Type] set to
"Master" and connected to Master
port (M) on RJ45 Splitter Cable
Sel Esc
Jog
|
DSI
REMOVE
Jog
|
DSI
REMOVE
Parameter 9 [Device Type]
set to "Slave" and
connected to Slave port (S)
on RJ45 Splitter Cable
ALT
Jog
REMOVE
9 ALT
6 Jog
3
. 0 +/- DSI
REMOVE
M
DSI / MDI Drive
S
Serial Converter
NEMA 4
Panel Mount Unit
or
NEMA 1 Bezel
with DSI / MDI
Hand Held
Parameter 9 [Device Type]
set to "Master" and
connected to Master port
(M) on RJ45 Splitter Cable Parameter 1 [Adapter Cfg]
set to "Auto" (default) or
"Slave" and connected to
Slave port (S) on
RJ45 Splitter Cable
Jog
|
DSI
REMOVE Sel Esc
ALT
Jog
REMOVE
Sel Esc
AK-U0-RJ45-TR1
Terminating Resistor
(end of network)
AK-U0-RJ45-TB2P
Two-position
Terminal Block
or
DSI / MDI Drives
or
Customer supplied RJ45 male-to-RJ45 male
cables with wires connected at pins 4 and 5 only.
Both the Master (M) and Slave (S) ports on the RJ45 Splitter
Cable operate as standard RS-485 ports in this configuration.
Sel Esc