Rockwell Automation Flex/WebPak 3000 DC Drive AC Line Discon Kit 1.5-30 HP-230VAC, 3-60 HP-460VAC - Manual (Page 2)

2 AC Line Disconnect Kit for FlexPak 3000 and WebPak 3000 Drives
Installing the AC Line Disconnect Kit
Two sets of instructions follow. The first describes installing the AC Line Disconnect on drives not equipped
with a NEMA 1 enclosure. The other describes installation on drives with the enclosure. Make sure you follow
the instructions appropriate to your drive.
Installing the AC Line Disconnect Kit on Drives Without a NEMA 1 Enclosure
Step 1. Turn off, lockout, and tag power to the drive.
Step 2. Remove the cover from the drive, if necessary.
Step 3. Disconnect the input AC power line connections to the drive’s terminal block as shown in figure 2A.
Table 2 – Contents of the AC Line Disconnect Kit 1
1.
See figure1for illustrations of the kit contents.
Item Description Qty Reliance Part Number
1 AC Line Disconnect for M/N 901FK0101
(1.5 HP to 25 HP @ 230 VAC, 3 HP to 50 HP @ 460 VAC 1 65242-100NSX
AC Line Disconnect for M/N 901FK0201
(30 HP @ 230 VAC, 60 HP @ 460 VAC 1 65242-100SSX
2
Label 2 (81,82, 83)
2.
Label is to be attached to the disconnect switch.
1 410273-2A
3
Lock - left
3
3.
Item used only when installing the AC Line Disconnect Kit on a drive with a NEMA 1 enclosure.
1 610273-47A
4
Lock - right 3 1 610273-46A
5
M4 x 12 CCWS
3 8 719062-1 PGH
6 M4 x 80 4 419062-10AGY
7
M4 x 90
3 4 1419062-10AGZ
8 M4 Nut/washer 4 419063-200SG
9 M6 Nut/washer 3 429063-200SJ
10
Standoff Bracket
3 2 610276-45A
11
Washer (flat)
3 4 419064-1SG
12 Washer (split) 4 419064-100SG
13 Wire assembly (181) 1 610273-39R
14 Wire assembly (182) 1 610273-39S
15 Wire assembly (183) 1 610273-39T
16 1/4” Washer (split) 3 601748-3J
17 1/4” - 20 x 5/8” RHMS bolt 3 601742-8G
!
ATTENTION: Do not install modification kits with power applied to the drive. Disconnect and
lock out incoming power before attempting such installation. Failure to observe this precaution
could result in severe bodily injury or loss of life.