Rockwell Automation 1606-XLP XM Electronic Overspeed Detection System - Manual (Page 31)

Publication GMSI10-UM015B-EN-E - June 2011
Installing the XM Electronic Overspeed Detection System 31
Connecting the Secondary Power Supply
The secondary (redundant) power supply needs to be wired to all of the XM
modules in the XM EODS. Wire the secondary power supply to the XM
modules as shown in Figure 2.9. Then place a jumper between terminals 3 and
34 on the XM-442 terminal base to enable the XM-442 to monitor the EODS
secondary power supply.
Figure 2.9 Secondary Power Supply Connection
ATTENTION
The power connections are different for the XM-220 and
XM-442 modules.
+
-
Jumper connected to
terminals 3 and 34 on
XM-442