Bang & Olufsen BeoVision MX_4200 - User Guide - Manual (Page 31)

31
When the CONNECTIONS menu appears…
> If necessary, press ss or tt to select the options
that correspond to what you have connected to
the V.TAPE socket.
> Press ▲ or ▼ to step between menu items:
V.TAPE and AV.
> Press GO to store this setup.
Register extra equipment before
auto-tuning
If a video tape recorder, decoder or any other
extra equipment is connected to your
television, the connection is detected by the
television. You can check and confirm the
registration of the equipment involved.
CONNECTIONS
store GO
V. TAPE V. TAPE
AV DECODER
When the STAND ADJUSTMENT menu
appears…
Make sure that there is enough room for the
television to turn to the right and left.
> Press GO to start stand adjustment.
> If the adjustment is interrupted the text
‘ADJUSTMENT FAILED’ appears on the screen.
Remove obstacles preventing the television from
turning, and press GO to start adjustment again.
> Once adjustment is complete, the text
‘ADJUSTMENT OK’ appears, followed by the
STAND POSITIONS menu.
> To store a stand position for when the television
is switched on, press ss or tt to turn the
television and place it according to your viewing
position.
> To store a stand position for when the television
is switched to standby, Press ▼ to move to
TV STANDBY.
> Press ss or tt to turn the television and place it
as you wish.
> Press GO to store your positions.
Determine the centre position
If your television is equipped with the
optional motorised wall bracket, the
STAND ADJUSTMENT menu appears on the
screen. Once the centre position is
determined, select your favourite positions for
when the television is switched on and in
standby.
STAND ADJUSTMENT
CENTRE POSITION
adjust GO
ADJUSTING . . .
NOTE! For further information about stand
positions, refer to the chapter ‘Set positions for
the television to turn to’ on page 38.