Bang & Olufsen BeoLink Passive - Setting-up Guide - Manual (Page 3)

3
B E O L I N K S Y S T E M
The main room is the room in
which you have placed your
audio system and/or video
system (the main system).
The link room is where you are
about to install your BeoLink
Passive kit.
When you set up your BeoLink
Passive, we recommend the
following sequence:
1 Switch off your Bang & Oluf-
sen system and disconnect
the products from the mains.
2 Make the installation as de-
scribed in this guide.
3 Connect the entire system
to the mains.
We recommend that you fol-
low the instructions in this
guide carefully. If you have
never carried out cable instal-
lations before, we suggest you
leave it to your Bang &
Olufsen retailer.
Contents
4 Placement
7 Connections
9 Ready for use…
10 Maintenance
This guide describes how to in-
stall your BeoLink Passive kit in
a BeoLink (Master Link) distri-
bution system.
The User’s guide, which is also
supplied with the BeoLink
Passive kit, describes how to
operate the system once it has
been installed.
The BeoLink distribution system
enables you to control your
main system and to listen to it
in the link room. Your link room
must be connected to the main
room via a Master Link cable.
To join the Master Link cables
from the main system and from
the BeoLink Passive kit, a junc-
tion box is required.
The cable and box (and other
accessories) can be purchased
at your Bang & Olufsen dealer.
↑ The main room
The link room →