Baumfolder BAUM20: Pile Folder 1st Station (from mid 2006) - Instruction Manual - Manual (Page 22)

TP10243-5 PAGE 22
1.0 Control Panel BAN-5
Figure 1. Control Panel.
1.1 Displays
01) Large Display
Eight digit multi use display composed of 7-
segment LED’s.
02) Small Display
Three digit multi use display composed of 7-
segment LED’s.
03) Ten segment bar graph display
The suction length display is used to display the
Suction Length as a percentage of Sheet Length.
This allows a range from 5% to 50%.
1.2 Machine Status Indicators
04) Suction Indicator
The suction indicator will track the suction
output. The LED will turn on when the suction
output turns on.
05) Pile indicator
The indicator is lit when the feeder is in auto-
matic feed mode. The indicator will flash if the
feeder is in reverse mode (Continuous Feeder) or
moving down (Pile feeder)
+
h
0
+
+
+
1
2
3
4
5 6
7
8
9
10
BAUMFOLDER CORPORATION
9 13 11 16 26 27 22 23 4 5 7 6 15 3
18 19 20 21 34 35
1 29 30 31 32 33 25 28 24 2 8 12 10 14 17
36
06) Input Indicator
The input indicator shows the status of the suction
photo-eye.
07) Output Indicator
The output indicator lights when the Batch Preset
is reached and the user has selected a batching
option. The output indicator is lit during the time
the batching option is active.
Batching options are Feed interruption, Speed up
table, Marking table or Kicker.
1.3 Machine Control Pushbuttons
08) Main Drive Start
09) Main Drive Stop
10) Pump Start
11) Pump Stop
12) Feeder Start
13) Feeder Stop
14) Pile Feeder Up, Continuous Feeder Start
15) Pile Feeder Stop, Continuous Feeder Stop
16) Pile Feeder Down, Continuous Feeder Reverse
17) Emergency Stop