Baumfolder BAUM20: Pile Folder 1st Station (from mid 2006) - Instruction Manual - Manual (Page 63)

PAGE 63 TP10243-5
MANUAL USAGE
Use this manual when you need to know how to set-up your folder to end up with a particular folded
piece or, if possible, when planning the layout before printing the job. In most cases, the page numbers
and their orientations after the fold are included. Below is an explanation of how to read the diagrams in
this manual. On the next page is a quick explanation of the basic theory of buckle folding. Although
reasonable care has been taken to assure accuracy, Baumfolder Corporation does not assume any respon-
sibility for any errors that might inadvertently be contained in this manual. When trying a new fold, it is
always advisible to set up a test run to check for potential problems.
1. Refer to the diagram below. Visualize the sheet to be folded lying flat on the register table. The
edge toward the fold rolls is called the “LEADING EDGE”. The paper edge under the register guide
will be referred to as the “SIDE GUIDE”.
In this manual, each folding diagram has been
rotated clockwise 90 degrees from what is visualized
below so that they appear as pictured to the right.
The dotted lines represent the creases where the
paper has been folded.
SIDE
GUIDE
L
E
A
D
I
N
G
E
D
G
E
1 23
4
6 5
7 8
LEADING EDGE
S
I
D
E
G
U
I
D
E