Baumfolder BAUM20: Pile Folder 1st Station (from mid 2006) - Instruction Manual - Manual (Page 27)

PAGE 27 TP10243-5
2.1.6 Machine UsageStatus Parameters
Table 6. Machine Usage Status Parameter List
P50: Power On Time
This selection shows the time in 1/100 hour during the
main switch of the machine is on.
P51: Machine Run Time
This selection shows the time in 1/100 hour during the
main drive contactor of the machine is on.
P52: Total Input Sheets
This selection shows the total input counts in 1000
sheets
Exit Machine Setup and Diagnostic Mode
Pressing any of these keys will cause the controller to
change to a new mode.
2.2 Counter Setup Mode
Pushing this key puts the counter in counter setup
mode.
Counter setup mode is used to prepare the controller to
run a job. The large display (1) shows the batch preset on
the left-hand side and the batching output time on the right
hand side. The decimal points in the large display (1) will
move from side to side to indicate that a parameter may be
changed. The small display (2) shows the batching type. The
suction length display (3) is active.
Change Batching Type
The minus and plus buttons move through a list of four
output devices. The chosen Type is then activated when the
batch down-count goes to zero. Feed interruption stops the
feeding of sheets for the batching time setting.
# Function Type Variable Displayed
P50 Power on time Machine Status Based on Inputs Time in 1/100 Hours
P51 Machine run time Machine Status Based on Inputs Time in 1/100 Hours
P52 Total Input Sheets Machine Status Based on Inputs Number in 1000 Sheets
h
0
+
The speed up-table output activates the marking table
output for the batching time duration.
The MKE mode is an unavailable option.
The kicker is a future feature.
The output types are represented by animated symbols.
The sequence of frames for the animations is shown in
table 7.
Table 7. Output Type Animations
Batch Preset Adjustment
These buttons cause the batch preset value to increment or
decrement. The preset will be reloaded after the user leaves
the setup mode only if the value has been changed.
+
Feed Interruption Speed Up Table MKE Table Kicker
Frame
1
Frame
2
Frame
3
Frame
4
Frame
5
Frame
6
Frame
7
Frame
8
Not
Available
Future
Feature