Baumfolder Impositions and their setups - Manual (Page 5)

Impositions and their setup
old
.
apsets (both sides).
8- Page, Parallel over & over fold Par: 1,2,4
9. Folds up in the first plate ¾ of the length of the sheet plus 3/16 of an
inch. Down in the second fold plate ¼ of the length of the sheet.
Deflect the third fold plate and into the forth fold plate ¼ of the length of
the sheet minus 1/16 inch. Insert one thickness strip of the paper you
are running in the number one, two, three and four gapsets (both
sides). Insert four thickness strip of the paper you are running in the
number five gapsets (both sides).
12-page book saddle stitch Par: 1,2 8pg: 2
10. Folds up in the first fold plate 1/3 of the length of the sheet. Down
into the second fold plate 1/3 of the length of the sheet and deflects
past number three and four fold plate. Score in the center as you
leave the parallel unit then onto the cross-carrier. Then into the
second unit (eight page) deflecting past the number one fold plate
down into the second fold plate ½ the width of the sheet. The fold
should be on the score. Deflect past the number three and four f
plate. In the parallel unit, insert one thickness strip of the paper you
are running in the number one, two and three gapsets (both sides)
Insert three thickness strips of the paper you are running in the
number four and five gapsets (both sides). In the second unit (eight page), insert three thickness
strips of the paper you are running in the number one and two gapset (both sides). Insert six thickness
of the paper you are running in three, four, and five g
12-page book, saddle stitch Par: 1,2 8pg: 1
11. Folds up in the first fold plate 2/3 plus 3/16 of an inch.
Folds down in the second fold plate 1/3 plus 1/16 of an
inch. Deflect past number three and fourth fold plates and
score in the center as it leaves the parallel unit. Then the
sheet travels onto the cross-carrier into the number one
fold plate in the second unit (eight page) one half of the
width of the paper. It then deflects past second, third and
fourth fold plate. Insert one thickness strip of the paper
you are running in the number one and two gapsets (both
sides). Insert three-thickness strips of the paper you are
running in the three, four, and five gapsets (both sides) in
the parallel unit. In the second unit, (8-page), insert three-
thickness strips of the paper you are running in the
number one gapsets (both sides). Insert six thickness strips of the paper you are running in two, three
four, and five gapsets (both sides).
( continued )
Baumfolder Corporation 1660 Campbell Rd., Sidney, OH, USA 45365 1-800-543-6107 Copyright г 2002