Baumfolder Impositions and their setups - Manual (Page 6)

Impositions and their setup
12-Page letter fold-heads out Par: 1 8pg: 1,2
12. Folds up in the number one fold plate ½ the length of the
sheet. Then it deflects past the second, third and fourth fold
plates. Then scores 1/3 of the width of the sheet minus 1/8 of
an inch from the right side, side away from the side guide,
second score 2/3 of the width of the paper as it leaves the
parallel unit. Then the folded sheet goes onto the cross-
carrier then into the second unit (8-page), up in the first fold
plate 2/3 of the width of the paper plus 1/8 of an inch, down
into the second fold plate 1/3 of the width of the paper.
Deflect past third and fourth fold plates. Insert one thickness
strip of the paper you are running in the number one gapsets
(both sides). Insert two thickness strip of the paper you are
running in the second, third, fourth, and fifth gapsets (both
sides) in the parallel unit. In the eight-page unit, insert two-thickness strip of the paper you are
running in the number one and two gapsets (both sides). Insert six thickness strip of the paper you
are running in the three, four, and number five gapsets (both sides). The folds in the eight-page unit
should be folded on the score made on the parallel slitter shaft.
12-Page letter fold-heads in Par: 1 8pg: 1,3
13. Folds in the number one fold plate ½ the length of the sheet.
Then deflects past the second, third, and fourth fold plate. Score
1/3 of the width of the paper minus 1/8 of an inch from the left
side of the sheet; guide side, score 2/3 of the width of the sheet
plus 1/16 in the slitter shaft as it leaves the parallel unit. Then
onto the cross-carrier into the first fold plate in the second unit,
(8-page), 1/3 the width of the paper minus 1/8 of an inch. Then
deflects past the second fold plate into the third fold plate 1/3 of
the width of the sheet plus 1/16 of an inch. Deflect past the fourth
fold plate. Insert one thickness strip of the paper you are
running in the number one gapsets (both sides). Insert two
thickness strip of the paper you are running in the numbers two,
three, four, and five gapsets (both sides) in the parallel unit. In
the 8-page unit, insert two- thickness strip of the paper you are running in the number one, two, and
three gapsets (both sides). Insert six thickness strip of the paper you are running in the number four
and five gapsets (both sides).
( continued )
Baumfolder Corporation 1660 Campbell Rd., Sidney, OH, USA 45365 1-800-543-6107 Copyright г 2002