Baumfolder Impositions and their setups - Manual (Page 7)

Impositions and their setup
12-Page letter fold-accordion Par: 1 8pg: 1,2
14. Folds up in the number one fold plate ½ the length of the sheet
and deflects the second, third, and the fourth fold plate in the
parallel unit. Then scores 1/3 of the width of the sheet from the
left side, side toward the side guide on the register, The second
score will be 2/3 of the width of the paper from the left side. On
the slitter shaft as the sheet leaves the parallel unit. Then onto
the cross-carrier into the second unit (8-page) number one fold
plate 1/3 on the width of the sheet. Then down into the second
fold plate 1/3 of the width of the sheet and deflect past the third
and fourth fold plate. Insert one thickness strip of the paper
you are running in the number one gapsets (both sides). Insert
two thickness of the paper you are running in the two, three,
four, and five gapsets (both sides) in the parallel unit. Insert two
thickness strips of paper in the number one and two gapsets (both sides). Insert six thickness strips of
the paper you are running in the number three, four, and five gapsets (both sides).
16-Page, three right angle books imposition Par: 1 8pg: 1 16pg: 1
15. Folds up in the number one fold plate ½ the length of the
sheet deflects past the second, third, and fourth fold plates.
Scores in one half of the width of the sheet as it leaves the
parallel unit. Then goes onto the cross-carrier and into the
second unit (8-page). Then folds in the number one fold
plate ½ the width of the sheet and deflect past the second,
third, and fourth fold plates (folds on the score made in the
parallel slitter shaft). Then it travels onto the second cross-
carrier (16 page cross-carrier) into the 16-page unit number
one fold plate ¼ the length of the original flat sheet and
deflects past the second, third, and fourth fold plates. Insert
one thickness strip of the paper you are running in the
number one gapsets (both sides). Insert two- thickness
strip of the paper you are running in the number two, three, four, and five gapsets (both sides), in the
parallel unit and score in the center of the width of the sheet as it leaves the parallel unit. Insert two
thickness strips of the paper you are running in the number one gapsets (both sides),and four
thickness strips of the paper you are running in the two, three, four, and five gapsets (both sides) in
the 8- page unit. Insert four thickness strips of the paper you are running in the number one gapsets
(both sides). Insert eight thickness strip of the paper you are running in the number two, three, four,
and five gapsets in the 16-page unit.
( continued )
Baumfolder Corporation 1660 Campbell Rd., Sidney, OH, USA 45365 1-800-543-6107 Copyright г 2002