Brother DCP-8045D - Manual (Page 123)

OPTIONAL ACCESSORIES 8 - 8
4
Plug the NC-9100h into connector P1 located on the main board
as shown in the illustration (press finmly) and secure the
NC-9100h with the two screws.
5
Put the metal shield plate back on and secure it with the two
screws.
6
Put the side cover back on.
7
Reconnect any additional interface cables that you removed.
8
Reconnect the power cable and then turn on the DCP power
switch.
9
Press the Test switch and print a network configuration page.
(See TEST SWITCH on page 8-10.)