Bird Technologies AT-800-Manual - Manual (Page 63)

Maintenance
45
1. Press the MENU key.
2. Press the TEST key.
3. Press the DISP TEST key.
4. The test is started.
5. Press the ESC key to end the test.
Self Test
The self test is similar to the operational tests run at
power up described on page 43, except for the keypad test.
Figure 16 Self Test
1. Press the MENU key.
2. Press the TEST key.
3. Press the SELF TEST key.
4. To test the keypad, press each key (except ESC
and ON).
Note: The hexadecimal value next to Key-
pad corresponds to the key pressed. If the value
does not change for each key, refer to Trouble-
shooting in this section.
5. Press the ESC key to stop the test.
Firmware Rev: 10MAR94
NVRam:
Rom:
EEprom:
Ram:
A/D:
Tempr:
PLL:
Keypad:
Pass
Pass
Pass
Pass
Pass
Pass
Pass
<Press ESC to continue>