Blizzard Lighting AutoBahn 8 - Manual (Page 7)

Page 7
AutoBahn™ 8 User Manual - Rev. A (c) 2014 Blizzard Lighting, LLC
SETTING THE NETMASk:
This allows you to choose from the 3 commonly used network mask
configurations that you can change per your system requirements.
Enter the main menu by pressing the <MENU> button, then use
the <Up/DOWN> buttons to highlight “3. Set Netmask”. Press
the <ENTER> button. Then use the <Up/DOWN> buttons to scroll
through the 3 choices and push the <ENTER> button when your
selection is highlighted.
To finish setting the netmask, you must save your changes by using
the <Up/DOWN> buttons to scroll to “Enter”, and then push the
<ENTER> button.
DMX pORT SETTINGS:
Enter the main menu by pressing the <MENU> button, then use
the <Up/DOWN> buttons to highlight “4. Set DMX port”. Press
the <ENTER> button. Then use the <Up/DOWN> buttons to scroll
through the DMX in/out port selections and push the <ENTER> button
when highlighted.
1.) DMXIN port A/B
DMX IN Port A/B can be set as “input” or “disabled” status. “Univ”
(Universe), can be set within the range 0.0 - F.F. When the DMX Port is
set as “input”, the Port Mode can be set as “normal” or “Backup”.
For all of the DMX Port Settings on page 8, use the <Up/DOWN>
buttons to scroll through your choices, and push the <ENTER> button
to confirm. Repeat this process for each group as necessary.