Blomberg smarTouch BUXB20 - Manual (Page 27)

26 EN
and program cancellation will not be
possible.
Starting Your Machine
Open the tap.
•
Plug the mains plug into the wall
•
socket.
Open the door.
•
Press On/Off button.
•
Check if the salt and rinse aid
•
indicators light and add salt and/or
rinse aid if needed.
Place the dishes.
•
Check if the upper and lower
•
impellers rotate freely.
Put sufficient amount of detergent
•
in the detergent dispenser and
close its lid.
Start the program by pressing
•
Start/Pause/Cancel button.
WARNING:
Pay attention not to open the door of
the machine when it is running. Stop
the machine by pressing Start/Pause/
Cancel button if you have to open the
door. Then, open the door. There may
be a rush of vapor when you open
the door of your machine. Be careful.
Close the door and press Start/Pause/
Cancel button again. Program will
resume running.
Key lock will be activated 30
•
seconds after the program starts
and ”Key Lock Activated” will be
displayed.
Energy saving system will be
•
activated 90 seconds after the
program starts and the display is
dimmed. If you touch the button
again, display brightness returns
to its original status.
“End” will be displayed when the
•
program is over. The amount of
water and energy consumed will
be displayed consecutively.
Press the On/Off button to turn off
•
your machine when the program
is over.
Close the tap.
•
Unplug the mains plug from the
•
wall socket.
Leave your dishes in the machine
•
for about 15 minutes after they
are washed in order to have them
cooled down. Your dishes will dry
in a shorter time if you leave the
door of your machine ajar during
this period. This will increase
the drying effectiveness of your
machine.
Selecting the Reference
Program
Press the On/Off button to turn
•
on your machine when its door is
open. Then, press the Start/Stop
button for 10 secs.
“Settings” will be displayed and
•
countdown will start from 10 secs.
You will enter in the “Settings”
•
menu at the end of the countdown
and the language selection menu
“Language” will be displayed.
“Ref. Program” will be displayed
•
when you press the Start/Stop
button once.
Press and hold the Start/Stop
•
button for 5 secs to enter the
reference program menu.
Press the Start/Stop button to
•
display ON or OFF options.
Press and hold the Start/
•
Stop button for 5 secs to save
your selection. “Saved” will be
displayed.
Turn off the machine by pressing
•
the On/Off button to exit the menu.