Boomba Racing ST/2.0 Focus Fusion Pulley Alignment Tool Kit - Manual (Page 2)

1 Remove plastic vacuum hose from rubber
adaptor on the top of valve cover (leave
rubber adaptor in place).
13
Remove the ignition coils.
14
Disconnect the fuel pressure sensor and
remove the fuel pump cover.
15
Remove the bolt holding the wire harness
bracket.
16
Remove the wire harness bracket.
17
Remove the valve cover.
18
Remove the vacuum line holder from the
bracket.
19
Remove the vacuum pump.
20
Remove the vacuum pump drive cover.
21
Remove the AC belt. Gently force it off the
pulley with a screw driver while rotating
the crank shaft clockwise.
22
Force the belt tensioner counterclockwise
and remove the main belt.
23
Manually move the crank shaft clockwise
until the intake cam lobes start moving off
the valve pushers.
24
Disconnect and remove the crank position
sensor.
25
Remove the engine block plug.
26
Rotate the crank shaft clockwise until it is
roughly 30 degrees off the vertical.
27
Select the crank shaft lock tool from the
installation tool kit ( sold separately).
28
Install the crank shaft lock tool in place of
the engine block plug.