Boomba Racing ST/2.0 Focus Fusion Pulley Alignment Tool Kit - Manual (Page 4)

51
Install the ignition coils. Install the BOV
solenoid. Install the fuel pump cover.
Connect the wire harness connectors.
Connect the vacuum lines.
52
Install and secure the air supply ducts.
45
Install the engine block plug. Connect the
wire harness to the Crank shaft position
sensor.
46
Hold the cam shaft in place with the open
end of the wrench and install the vacuum
pump drive bolt. Torque the bolt to 46 ft
lbs. Apply a slight amount of Gasket
Maker to the marked area.
47
Install the vacuum pump and the vacuum
pump drive cover.
48
Apply a slight amount of Gasket Maker to
the marked area.
49
Apply a slight amount of Gasket Maker to
the marked area.
50
Install the valve cover and secure it to the
engine head.
55
Remove the idler pulley.
56
Remove the bolt and the washers from
the idler pulley.
53
Remove the belt tensioner pulley.
CAUTION THIS IS A LEFT HAND
THREAD BOLT.
54
Remove the water pump pulley.
59
Install the AC belt slowly forcing it on the
AC pulley while turning the crank shaft
clockwise.
60
Install and secure the under tray, the
wheel well liner and the right front wheel.
57
Install the bolt and the washers on the
Boomba Racing idler pulley.
58
Install the pulleys. Install the belt.