Bully Dog 53252 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 14)

13
5. Install the Bully Dog CCV tube over the stock CCV breather tube and secure the connection
by tightening the #8 clamp. Connect the other end of the Bully Dog CCV tube to the Stage 2
Tube’s recirculation connection point and tighten the clamp to secure the connection.
6. Place the air filter over the intake tube on the inside of the RFI intake bottom. Position
the air filter onto the end of the tube so that the filter points slightly downward and then
tighten the air filter clamp with a flat head screw driver. The clamp should be tight enough
that it is very difficult to pull the air filter off of the tube with your bare hands.
RFI Installation