Bully Dog 53106 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 6)

5
RFI COLD AIR INTAKE
Installation
Installation is
very simple and
can be separated
into three parts:
Removing the
Stock Intake,
Preparing the Bully
Dog RFI Intake and
Installing the Bully
Dog RFI Intake. The complete installation of the RFI Cold Air
Intake system should take about 20 minutes. The assembly
diagram shows how the parts of the intake fit together in
sequence.
Removing the Stock Intake
1. IMPORTANT: Before beginning installation, disconnect
your battery at the negative
terminal. Failure to disconnect
the battery could result in
personal injury and/or damage to
your vehicle.
Stock Intake Tube (3)
Band Clamp (3)
Band Clamp (3)
Stock Intake Box (4)
Mass Air Flow Sensor (2)