Bully Dog 83420 Rapid Flow - Manual (Page 9)

10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 83420
13. At this point, if you need the
extra Straight Pipe cut it to the
desired length. Keep in mind that
you need 3 inches of overlap when
you cut the pipe. If you don’t need
the Straight Pipe, simply install the
Muffler directly into the Cross Mem-
ber section. If the Straight Pipe is
not needed, you will have an extra
straight pipe and an extra clamp left
over when you are finished.
14. Once the entire exhaust system
is installed, inspect the system to
ensure that no part of the exhaust is
in direct contact with the chassis or body; adjustments may be necessary. Having any part of the exhaust system in direct
contact with any part of the body or chassis will the cause the exhaust to rattle.
15. Return to each of the Clamps and tighten with a 9/16” wrench. Again, do not over tighten Clamps.
9/16”