Bully Dog 82201 Rapid Flow - Manual (Page 5)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82050,82201
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.
1.Use a sawzall to cut the exhaust di-
rectly behind the muffler.
2. Cut the Straight Pipe in front of the muffler.
3. Cut the stock Down Pipe just after
the bend.
4. Loosen the stock band clamp using
a 7/16” deep socket where the stock down pipe
is connected to the turbo. The stock band clamp
will be used later so don’t remove it, just loosen
it enough to remove the stock down
pipe.
5. To make removing the Hangers an
easier process it is recommended that
you use a silicone spray lubricant to
spray each of the rubber hangers holding the
stock exhaust.
6. Remove each piece of the stock exhaust sys-
tem, including the stock exhaust hangers.
Cut directly in front of the Muffler
Remove all the necessary exhaust hangers
7/16”
Loosen Stock Band Clamp