Bully Dog 53100 Rapid Flow Induction - Manual (Page 5)


RAPID FLOW INDuCTION
INSTALLINg ThE rFI
1. Remove the lid from off of the RFI, to remove
the lid pull outward on the black button and
then simply lift the lid off of the RFI.
2. With the lid removed set the RFI filter housing
down into the engine bay where the stock air
box usually fits.
3. Secure the intake using three of the five bolts
that were removed from the stock system. For
convenience and ease, use an extension while
tightening the bolts.
4. Connect the intake tube to the RFI. Secure the
connection using the band clamp on the end of
the intake tube.
5. Place the Mass Air Flow sensor into the RFI out-
let tube as it was installed in the stock intake
system. Secure the Mass Air Flow sensor using
the two replacement screws included with the
RFI kit.
The stock screws will not work to secure
the Mass Air Flow sensor becuase the thread
pattern is different.
6. Install the filter on to the RFI outlet. Use a flat
head screw driver to tighten the band clamp
that goes around the filter.
7. To complete the installation slide the lid into
place and secure the lid using the snap.