Bully Dog 40300 PMT advanced vehicle downloader, controller, monitor and gauge - Manual (Page 43)

42
Intr
odu
ctio
n
Par
ts D
escription
PM
T In
sta
llati
on
Inte
rne
t U
pda
tes
App
end
ix
GAUGE SETUP
Enter to change the vehicle parameters displayed on the four gauge locations in the Main
Screen. This is also where you can see all of the most up-to-date vehicle parameters available
to your vehicle make and model after running an internet upgrade.
Selecting a vehicle parameter to display in a particular location is done by highlighting the gauge
location and then highlighting the desired vehicle parameter.
Once the correct vehicle parameter for a gauge
location has been highlighted, you do not need to
press another button to select that vehicle param-
eter. Simply highlighting the vehicle parameter
makes it active in that location.
Set Gauge 2
Set Gauge 3
Set Gauge 4
Go Back GAUGE SETUP
Set Gauge 1
Speed
RPM
Throttle
Coolant
Gauge 1
Use the Up and Down Arrows
to Change the Gauge Function
Pyro 2
Speed
Boost
to Main Menu
To highlight a different gauge location press
the selection button that coincides with that
gauge location. So to select gauge location
, press the second button down on the left
hand side of the PMT. To select the 4th gauge
location press the bottom button or the 5th
button down on the left side. Use the large Up Down Buttons to
highlight a particular vehicle parameter for
any of the gauge locations.
Notice that upon entering the gauge setup menu that, Set Gauge , is highlighted in black. When a
gauge location is selected it is highlighted in black on the left and it also appears above the vehicle
parameter selection box.
Op
era
ting
Ins
tru
ctio
ns
OPERATING INSTRuCTIONS