Calculated Industries 4095-B Pocket Reference Guide - Manual (Page 16)


MATH CHAIn
 (Repeats options)
MATH OrdEr
ENTERING DIMENSIONS
Linear Dimensions
When entering feet-inch values, enter dimen-
sions from largest to smallest — feet before
inches, inches before fractions. Enter fractions
by entering the numerator (top number),
pressing
 (Fraction Bar key) and then the
denominator (bottom number).
Note: If a denominator is not entered, the
fractional setting value is used.
Examples of how linear dimensions are
entered (press
 after each entry):
DIMENSIONS KEYSTROKES
5 feet
 
5 feet, 1 ½ inches
      
17.5 meters
    
1250 millimeters
     
Square and Cubic Dimensions
Examples of how square and cubic dimensions
are entered (press
 after each entry):
DIMENSIONS KEYSTROKES
14 square inches
   
11 square feet
   
P
OCKET
R
EFERENCE
G
UIDE
— 17