Boss Audio Systems SP-505 - Manual (Page 32)

32
Chapter 1. Playing samples from the pads
Playing a sample backward
(Reverse Playback)
“Reverse playback” plays a sample backward, producing the
effect similar to when a tape is played in the reverse
direction.
For each sample, you can select one of the following reverse
settings.
OFF: Don’t reverse
ON: Reverse
1. Press the pad of the sample for which you want to
make settings.
2. Press [WAVE EDIT].
3. Use CURSOR [ ↓ ] [ ↑ ] to move the cursor to the
“Reverse” line.
fig.01-06a
4. Use the VALUE dial to select “OFF” or “ON.”
● If you want to make settings for another sample in the
same pad bank, press the pad for the sample that you
want to set, and perform steps 3 and 4.
● If you want to make settings for a sample in a different
pad bank, switch pad banks (p. 30), press the pad for the
sample that you want to set, and perform steps 3 and 4.
5. Press [EXIT], [SONG], or [PTN] to return to the Play
screen.
Never turn off the power while the display indicates
“Keep Power On!”
Playing an audio input signal
(EXT Source)
Even without sampling, the SP-505 lets you use a pad to
control an internal input sound, and start/stop the sound
and apply effects in the same way as a sample.
1. Connect a CD player or mic.
Connect your CD player to the LINE IN jacks, or your
mic to the MIC jack.
* It is not possible to use digital input (COAXIAL/OPTICAL
jacks) as an EXT source.
2. Press [SOURCE SELECT] to select the input.
Select either LINE IN or MIC, depending on the jacks to
which you connected your CD player or mic.
3. When you press [EXT SOURCE], getting it to light, the
external input source will be heard.
When you press [EXT SOURCE] once again to make it go
dark, the external input source will no longer be heard.
4. Use the REC LEVEL knob to adjust the volume.