Boss Audio Systems SP-505 - Manual (Page 78)

78
Chapter 15. Appendices
Error message list
■ Sampling related
Memory Full!
❍ Sampling is not possible because there is no space in
user memory.
→ Delete unneeded sample data. (p. 49)
❍ Ran out of user memory during sampling.
→ Delete unneeded sample data. (p. 49)
❍ Not enough memory to use the Chop function.
→ Delete unneeded sample data. (p. 49)
❍ Not enough memory to use the Scale function.
→ Delete unneeded sample data. (p. 49)
Awaiting Digital Signal
❍ You are attempting to sample the signal from
DIGITAL IN, no signal is detected.
→ Check whether a digital signal is being output from the
connected digital device. (For details, refer to the manual
for the connected device.)
❍ The sampling frequency of the signal from DIGITAL
IN is not 44.1 kHz.
→ Set the sampling frequency to 44.1 kHz. (For details refer
to the manual of the connected device.)
Not Sampling Bank!
❍ Sampling is not possible since the Chop bank or the
Pitch bank is selected.
→ Switch to another pad bank.
Protected!
❍ Deletion is not possible because the sample is
protected.
→ Turn off the protect setting of the sample. (p. 73)
❍ Overwriting is not possible because the sample is
protected.
→ Turn off the protect setting of the sample. (p. 73)
Protected! Sure?
❍ Initialization is not possible because the sample is
protected.
→ To continue with initialization, press [F1] (YES).
To cancel, press [F2] (NO).
Too Busy
❍ Notes are not sounded in time.
→ Reduce the number of notes.
■ MIDI related
MIDI Off Line!
❍ There is a problem with the MIDI cable connection.
→ Check whether the MIDI cable has been disconnected or
broken.
MIDI Buffer Full!
❍ Too many MIDI messages were received all at once,
and the SP-505 was unable to process all of them.
→ Reduce the amount of MIDI messages being transmitted
to the SP-505.
MIDI Error!
❍ A MIDI message was not received correctly.
→ Check whether the MIDI cable has been disconnected or
broken.
→ Check whether invalid MIDI messages are being
transmitted.
■ Song/pattern recording related
Memory Full!
❍ Song/pattern cannot be saved because there is
insufficient space in user memory.
→ Delete unneeded songs or patterns.
Too Much Data!
❍ Recording/playback is not possible because there is too
much performance data, or because the BPM is too fast.
→ Lower the BPM. Delete unneeded performance data.
Pattern REC Full!
❍ No more data can be recorded in the pattern, since the
maximum number of notes that can be recorded has
been exceeded.
→ Delete unneeded data from the pattern being recorded.
(p. 59, 60)