Clay Paky SUPERSHARPY (C61390 ) - Manual (Page 9)

9 SUPERSHARPY
Main Menu Level 1 Level 2 Level 3 Choices / Values
I NFORMATION
System Errors Read / Reset
Fixture Hours
Total Hours Read
Partial Hours Read / Reset
Lamp Hours
Total Hours Read
Partial Hours Read / Reset
Lamp Strikes
Total Strikes Read
Partial Strikes Read / Reset
System Version
CPU brd Fw.rev. / Hw.rev.
com.dev Fw.rev.
0:PT-3f Fw.rev. / Hw.rev.
1:6-Ch Fw.rev. / Hw.rev.
2:6-Ch Fw.rev. / Hw.rev.
Board Diagnostic
0:PT-3f Status / Err%
1:6-Ch Status / Err%
2:6-Ch Status / Err%
DMX Monitor Channels Value / Percentage
Fans Monitor
PwrSp Speed (RPM)
PwrSp Speed (RPM)
Lamp Speed (RPM)
Lamp Speed (RPM)
Lamp Speed (RPM)
Head Position
X
Y
Z
Good Pkt
Bad Pkt
Uart Err
Sensor status Channels n.a / On / Off
Rot Gobs Indexing
Network parameters
IP Address
IP Mask
MAC Address
M ANUAL
C ONTROL
Lamp On / Off
Reset Yes / No
Channels Value / Percentage
T EST
A DVANCED Access Code 1234
Service Mode On / Off
Upload Firmware Yes / No
Setup Model Yes / No
Calibration Channels 000 - 255
Rot. Gobo Indexing Yes / No
Continue ➔