Brother NC-4100H - Manual (Page 78)

CHAPTER 6 NOVELL NETWARE PRINTING
6-11
9. Click on the button to select the print queue volume. Change the directory
context if necessary, then select the desired volume (Objects) and click OK.
Click Create to create the print queue.
10. Change context if required and then double click the name of the printer you
created previously.
11. Click Assignments and then Add.
12. Change context if necessary and select the print queue you created. Click
OK and then OK again, and then exit NWADMIN.
13. Start the appropriate BRAdmin application, and select the correct print
server you wish to configure (by default, the node names will begin with
BRN_xxxxxx_P1, BRN_xxxxxx or BRO_xxxxxx_P1 if it is a Brother NC-
2000 series print server).
You can find the NetWare server name and MAC address by printing out the printer
configuration page. Refer to the Quick Setup Guide for information on how to print
the configuration page on your print server.
14. Double click the appropriate print server. You will be prompted for a
password, the default password is "access".
15. Now select the NetWare tab.
16. Select Remote Printer as the Operating Mode, select the name of your
PSERVER NLM as the Print Server Name and select the number of the
printer from step 6 as the Printer Number.
The same service assigned by NetWare print server cannot be used for both queue
server mode and remote printer mode. If you want to enable remote printer
capabilities on a service other than the default NetWare service, you must define new
services that are enabled for NetWare and for the desired port. Refer to
Appendix B
in this manual for information on how to do this.
17. Click OK. And exit BRAdmin.
You must now unload the PSERVER NLM from your NetWare file server console
and then reload it in order for the changes to take effect.
As an alternative to Brother's BRAdmin application or the Novell NWADMIN
application, you can use the standard Novell PCONSOLE utility in conjunction with
Brother's BRCONFIG program to set up your print queues. BRCONFIG program
will be installed at the same time when you install the BRAdmin and you can find the
BRCONFIG in the menu "Start/Program/Brother BRAdmin utilities". Otherwise you
can find it in the "Brother Print Server Configuration Utility" diskette. Note that if
desired, you may use a WWW browser or TELNET utility - instead of the
BRCONFIG utility).