Brother NC-4100H - Manual (Page 85)

CHAPTER 6 NOVELL NETWARE PRINTING
6-18
Assigning the Remote printer name and number using BRCONFIG
7.
a. Execute the BRCONFIG from the Windows menu or insert the Brother
Print Server Software diskette in Drive A: of your PC and type:
A:BRCONFIG
b. Select the Brother print server from the list of print servers. When you
get the message that the print server is connected, press the ENTER key
and type Where the default password "access" in response to the "#"
prompt (the password will not echo) and then press the ENTER key
again in response to the Enter Username> prompt. When you get the
Local> prompt, type:
SET NETWARE NPRINTER nlm number ON service
SET NETWARE RESCAN
EXIT
•
Where nlm is the name of the PSERVER NLM on your file server
•
Number is the printer number (must match the printer number you
selected during the PCONSOLE configuration in the previous
steps)
•
Service is the name of the service assigned by NetWare print
server name(where the default services are BRN_xxxxxx_P1 or
BRO_xxxxxx_P1 for the Brother printer, where "xxxxxx is the last
six digits of the Ethernet address (MAC address)).
For example, to set up remote "Printer 3" for an Brother printer with the print server
BRN_310107_P1 using the PSERVER NLM called BROTHER1PS, you would type:
SET NETWARE NPRINTER BROTHER1PS 3 ON BRN_310107_P1
SET NETWARE RESCAN
EXIT
•
You can also enter the remote printer name using your web browser by
connecting to the Brother print server using the TCP/IP protocol and selecting
the NetWare protocol configuration.
The same services assigned by NetWare print server name cannot be used for both
queue server mode and remote printer mode.
You must now unload the PSERVER NLM from your NetWare file server console
and then reload it in order for the changes to take effect.