DJI Naza-M - Manual (Page 32)

©2013 DJI Innovations. All Rights Reserved. 32 |
When used with other DJI products
The NAZA-M system communicates with other DJI products (e.g. H3-2D gimbal, BTU module, iOSD mini and iOSD
Mark II) via the CAN-Bus port ( ) of the NAZA PMU V2. You can plug new DJI products into any spare CAN-Bus
port, since CAN-Bus ports on NAZA-M, CAN HUB, GCU, iOSD mini, iOSD Mark II and 2.4G Bluetooth Datalink are
the same for the communications.
When there are not enough CAN-Bus ports for additional DJI products, then a DJI CAN HUB module is
recommended. The following diagram is for your connection reference.
Fig.1 Used with iOSD Mark II
Fig.2 Used with CAN HUB