Banner PresencePLUS Interface Modules - Manual (Page 4)

Banner Engineering Corp., 9714 Tenth Ave. No., Mpls., MN 55441 • Ph: 763.544.3164 • www.bannerengineering.com • Email: [email protected]
SCM Strobe Control Module
Accessories
Power Supplies
Models Input
Input
Cord Output
Output
Cable Used with
PSC-24 †
100-250V ac
50/60 Hz
North America
(NEMA 5-15)
24V dc ±5%
with voltage
regulation of ±1%
2.2 A max.
1.8 m (6')
2-wire
Unterminated
SCM Strobe
Control Module
PSC-24E †
Cont. Europe
(Schuko CEE 7)
Extension Cables
Models Length Configuration
DB910S † 3.0 m (10')
DB906S † 1.8 m (6')
Terminated both ends with 9-pin D-sub connector, for strobed lights
(one end male pins and opposite end female pins)
DB9YS † 1.8 m (6') Y cable for powering 2 lights from one supply, for strobed lights
† These models are not stocked and are non-returnable.
+24VDC J1
Test1
P/W1
Rise
1
Fall
DC GND
Shield 1
Flash 1
Signal Rtn 1
Shield 2
Flash 2
Signal Rtn 2
Power Input
J2
Test2
P/W2
Rise
2
Fall
5.4 mm (0.213") (x4)
5.8 mm (0.23")
182.0 mm
(7.17")
97.8 mm
(3.85")
9.7 mm
(0.38")
43.0 mm
(1.69")
62.3 mm
(2.45")
Figure 3. SCM Strobe Control Module dimensions