Banner PSDINA-24-4 DIN-Rail Power Supply - Manual (Page 2)

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN USA 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: [email protected]
PSDINA-24-4 DIN-Mount Power Supply
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering
Corp. will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned
to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of
Banner products. This warranty is in lieu of any other warranty either expressed or implied.
P/N 134840 rev. A
Specifications
Input Voltage 100 / 240V ac Nominal (85 to 264V ac)
Input Frequency 50 / 60 Hz
Input Current
(120 / 240V ac, 4A load)
2A / 1A
Inrush Current
(120 / 240V ac, 4A load)
20A / 45A (< 10 ms)
Output Voltage 24V dc Nominal (21.6 to 26.4V dc Adj.)
Output Current 4A
Output Power 96W
Holdup Time
(120 / 240V ac, 4A load)
>25 ms / >100 ms
Line Regulation
(85 –264V ac, 4A load)
<0.1%
Load Regulation
(0–4A load)
<0.8%
Temperature Regulation
(4A load)
<0.02% / °C
Total Output Regulation
(All conditions)
<±5%
Efficiency
(120 / 240V ac, 4A load)
81% / 87%
Output Ripple / Noise
(4A load)
Common Mode: <3.0% p-p
Normal Mode: <1.0% p-p
Leakage Current
(120 / 240V ac, 1A load)
<0.25 mA / <0.50 mA
Power Factor
(120 / 240V ac, 4A load)
0.55 / 0.50
Dielectric Strength
(10 mA, 1 minute)
3.0kV ac (input to output)
2.0kV ac (input to ground)
0.5kV ac (output to ground)
Output Over-Voltage
Protection and Indication Trip point: 30 to 33V dc (latching; cycle
ac power to reset)
Red LED: ON Green LED: OFF
Output Under-Voltage
Indication <19.5V dc
Red LED: ON
Green LED: ON
Output Over-Current
Protection and Indication Trip point: 110% to 150% of rated current
(output disable; auto-retry)
Red LED: OFF Green LED: Flashing
Operating Conditions Temperature: –10° C to +60° C
Derate load linearly to 50% from +50° C
to +60° C
Relative Humidity: 25 to 85%
Mounting Clearance Above, below, left, right: 25 mm (0.98")
Front: 15 mm (0.59")
Environmental Rating IP20
Weight 590 grams
Certifications
US
Standards – Emissions IEC61204-3 (CISPR 11 and CISPR 22
class B, IEC61000-3-2, IEC61000-3-3)
Standards – Immunity IEC61204-3 High severity levels
(IEC61000-4-2, IEC61000-4-3,
IEC61000-4-4, IEC61000-4-5,
IEC61000-4-6, IEC61000-4-11)
Standards – Safety UL508
Dimensions
61
[2.4"]
111
[4.4"]
110
[4.3"]
118
[4.6"]
97
[3.8"]