Automatic interface selection, Automatic interface selection -21 – Brother HL-1800 series User Manual
Page 67
CHAPTER 2 DEIVER AND SOFTWARE
2-21
A
A
u
u
t
t
o
o
m
m
a
a
t
t
i
i
c
c
I
I
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
S
S
e
e
l
l
e
e
c
c
t
t
i
i
o
o
n
n
This printer has an Automatic Interface Selection function. When the printer
receives data from the computer, it automatically selects the interface that is
appropriate.
When you use the parallel interface, you can turn the high-speed and bi-
directional parallel communications on or off by using the Parallel menu in
the INTERFACE mode on the printer control panel.
. Since the Automatic Interface Selection mode has been set at the
factory to ON, simply connect the interface cable to the printer.
If a Network board (Brother NC-4100h) has been installed, select NETWORK
mode on the printer control panel.
If you constantly use only one interface, we recommend that you select that
interface in the Interface mode. The printer allocates all of the input buffer to
that interface if only one interface is selected.