Garden Sun Heater HPS-C-PC Tabletop Heater - Manual (Page 6)

5
Assembly
STEP 1:
Attach post with burner
assembly onto heater
housing, using 4pcs 3/16"
Stainless bolts and M5X8
bolt / Nut M5/ washer, Keep
the access panel open.
For additional assistance or service,
please call: 888-775-1330.
STEP 2:
Attach ring weight to
base, using 4pcs
M6X20 bolts. STEP 4:
Insert ends of wire
guard into holes in
the post with burner
assembly flange and
put 3pcs washers into
the top of support bolt.
STEP 3:
Put 3pcs reflector spacers into the hole in
emitter using 3pcs nuts to firm the reflector
spacers inside of the emitter.Put M6X60
bolt through the emitter hole into the top
of the emitter,using 1pc nut to firm the bolt.
Attach emitter assembly to post using 4pcs
bolts and washers.
STEP 5:
Attach reflector to emitter
assembly,using 3pcs nuts.
STEP 6:
Put reflector cap through the
M6X60 bolt using finial to firm it.